Vector Signal Generator supporting frequencies of 100 kHz to 2.7/4/6 GHz

ACLR: -71 dBc (W-CDMA, Test-Model 1, 64DPCH, ≤+5 dBm)

Output level +23 dBm (CW, 400 MHz to 3 GHz)

Switching Time: <600 µs (List/Sweep mode)

Built-in wideband (160 MHz/120 MHz) baseband signal generator

Dual RF (Optional) provides two independent RF outputs

Dual Waveform Memory (Optional) enables two independently modulated signals per RF Output

Generate and output modulation signals of various communication systems such as 5G NR (sub-6 GHz), LTE-Advanced FDD / TDD (Optional)   UPDATED

Solution page:

5 GHz Band WLAN Device DFS Tests

The Vector Signal Generator MG3710A is a best-of-class, multi-function, signal generator with excellent RF and baseband performance. The MG3710A features wideband vector modulation and offers built-in baseband waveform generation with large-capacity memory to ensure maximum versatility. It supports all key mobile communications and wireless LAN standards, and it also has the exceptional performance required for emerging and proprietary wireless communications technologies. Dual RF and Dual Waveform options enable a single MG3710A to output up to four independently modulated signals. The MG3710A makes it easy to implement complex test scenarios that would normally require multiple synchronized signal generators, such as:

Wanted + Interference Signals for Receiver Blocking Testing

Wanted + Two CW Tones for Receiver Intermodulation Testing

Wanted + Delayed Signals for Multipath Testing

Multiple Wanted Signals for MIMO Testing

Multiple Wanted Signals for LTE-Advanced Carrier Aggregation Testing

For these multi-signal applications, the MG3710A eliminates the cost of extra signal generators, simplifies equipment setup and calibration, streamlines system operations and speeds measurement times. 

The following four types of waveform pattern can be used with the MG3710A

Built-in standard waveform patterns

Optional waveform patterns (sold separately) (MX3700xxA, MX3700xxB  NEW)

Waveforms generated by IQproducer waveform generation software (sold separately) (MX3701xxA)

IQ data generated by general-purpose signal-generation software and converted waveform patterns used by MG3710A

■ Main Performance and Specifications

Basic Performance

Frequency Range	100 kHz to 2.7/4/6 GHz (1stRF Opt-032/034/036)  100 kHz to 2.7/4/6 GHz (2ndRF Opt-062/064/066)
High Power Output	+23 dBm (CW, 400 MHz to 3 GHz)
SSB Phase Noise	<-131 dBc/Hz (typ.) (1 GHz, 20 kHz offset, CW)
ACLR	-71 dBc (W-CDMA, Test-Model 1, 64DPCH, ≤+5 dBm)
Switching Speed	<600 µs (frequency/amplitude, List/Sweep mode)

Baseband Performance

RF Band: Built-in,160 MHz*/120 MHz baseband generator 
(*: 802.11ac. Only when using MX370111A and MX370111A-002)

Large 64 Msamples waveform memory with optional expansion to 1024 Msampls

Pre-installed standard waveform patterns 
       LTE (E-TM1.1 to TM3.3), W-CDMA/HSDPA, GSM/EDGE, CDMA2000 1x/1xEV-DO, Bluetooth, GPS, GLONASS, QZSS, 
       PDC, PHS, Broadcast (ISDB-T/BS/CS/CATV), WLAN (IEEE802.11a/11b/11g), Mobile WiMAX

Signal generation with waveform generation software (IQproducer) 
       LTE/LTE-Advanced, WLAN 11a/b/g/n/j/p and 11ac, Mobile WiMAX, W-CDMA/HSPA, CDMA2000 1xEV-DO 
       TD-SCDMA, Fading, Multi-Carrier, DVB-T/H, TDMA

Expansion Options

AWGN Generator [Opt-049/079] 
       C/N: ≤40 dB

BER Measurement Function [Opt-021] 
       Input bit rate: 100 bps to 40 Mbps

USB Power Sensor (sold separately) 
       Supports connection of two USB power sensors max. 
       ♦ Frequency Range: 50 MHz to 6 GHz [MA24106A], 10 MHz to 18 GHz [MA24118A], 10 MHz to 26 GHz [MA24126A]  etc.

MIMO Signal Source: Supports local input [Opt-017] 
       Baseband clock, local and trigger signals can be shared between up to four MG3710A units to output phase coherency signals 
       synchronized with the signal output timing for configuring an 8x8 MIMO system.

Additional Analog Modulation Input for 1stRF/2ndRF [Opt-050/080] 
       Opt-050/080 extends to two internal modulation sources (AM/FM/ΦM) and one external modulation source supporting 
       simultaneous two-signal modulation.

Communications Interfaces

Standard 1000BASE-T, GPIB, and USB interfaces

Built-in SCPI, MG3700A/MS269xA/MS2830A compatibility modes

Технологии

LTE

WCDMA/HSPA/HSPA evolution

TD-SCDMA

Тестирование базовых станций

Bluetooth

WLAN

WiMAX

IoT (Internet of Things)

Шнур питания

Руководство по эксплуатации

CD-ROM с документацией

Номер в Госреестре	Наименование СИ	Обозначение типа СИ	Изготовитель	Срок свидетельства или заводской номер
55303-13	Генераторы сигналов	MG3710A, MG3740A	Фирма "Anritsu Corporation", Япония	30.08.2023