The HX2410 CW to CMOS Conversion Amplifier is intended for use as a peripheral component in precision oscilloscope test applications. The HX2410 eliminates trigger induced jitter that is caused by the low slew rate of low frequency sinusoidal (CW) trigger signals, ultimately resulting in inaccurate oscilloscope measurements. The proprietary architecture maintains the integrity of an ultra low phase noise sinusoidal (CW) signal while converting it to a CMOS Logic level exhibiting the absolute lowest jitter available (see Figures 2-3). Holzworth products are 100% finalperformance tested for phase noise (jitter) verification.
The HX2410 CW to CMOS Conversion Amplifier is also available with Holzworth’s multi-channel RF Synthesizer products as an integrated option. Inquire directly with Holzworth Instrumentation or a Sales Representative for more information.
Key Specifications and Features:
- Convert Sinusoid (CW) to CMOS Logic
- Reduce effects of Trigger Jitter
- Increase Oscilloscope Accuracy
- Trigger Frequency: 5MHz to 500MHz
- Integrated Ultra Low Noise Bias Network
The HX2410 CW to CMOS Conversion Amplifier is intended for use as a peripheral component in precision oscilloscope test applications. The HX2410 eliminates trigger induced jitter that is caused by the low slew rate of low frequency sinusoidal (CW) trigger signals, ultimately resulting in inaccurate oscilloscope measurements. The proprietary architecture maintains the integrity of an ultra low phase noise sinusoidal (CW) signal while converting it to a CMOS Logic level exhibiting the absolute lowest jitter available (see Figures 2-3). Holzworth products are 100% finalperformance tested for phase noise (jitter) verification.
The HX2410 CW to CMOS Conversion Amplifier is also available with Holzworth’s multi-channel RF Synthesizer products as an integrated option. Inquire directly with Holzworth Instrumentation or a Sales Representative for more information.
Key Specifications and Features:
- Convert Sinusoid (CW) to CMOS Logic
- Reduce effects of Trigger Jitter
- Increase Oscilloscope Accuracy
- Trigger Frequency: 5MHz to 500MHz
- Integrated Ultra Low Noise Bias Network
- Узнайте по тел.: +7 (495) 105 96 88
- Напишите нам письмо: info@micro-electronics.ru
- Узнайте по тел.: +7 (495) 105 96 88
- Напишите нам письмо: info@micro-electronics.ru
| Parameter | MIN | TYP | MAX | Units | Comments |
|---|---|---|---|---|---|
| Input Frequency Range | 5 | 500 | MHz | ||
| Input Power Range | 0 | 12 | dBm | Minimum varies with frequency. See Fig. 4 | |
| Output Impedance | 50 | ohms | |||
| Output Amplitude (no-load) | 5 | VP-P | |||
| Output Amplitude (50 ohm) | 2.5 | VP-P | |||
| Additive Phase Noise | -160 | dBc/Hz | 100MHz, 10kHz Offset, PIN=+10dBm | ||
| RMS Phase Jitter | |||||
| 10Hz to 100Hz | 5 | fs | 100MHz, PIN=+9dBm | ||
| 20kHz to 20MHz | 6 | fs | 100MHz, PIN=+9dBm | ||
| Rise Time / Fall Time (Tr/Tf) | 900 | ps | 10% - 90% (500MHz Oscilloscope) | ||
| DC Voltage Supply | 7 | 12 | VDC | SMB Connector | |
| Form Factor (L x W x H) | 1.75in x 1.5in x 0.5in, not including SMA/SMB connectors | ||||
| 1Final performance verification at 100MHz, PIN=+10dBm | |||||
| 2Specifications are subject to change per the discretion of Holzworth Instrumentation, Inc. | |||||
Товар |
|
|
|
Модели и Опции |
Описание |
Цена | Заказать |
0
| Модели |
|
HX2410
|
Усилитель-преобразователь, входная частота 5 - 500 МГц, CW - CMOS Logic
|
По запросу |
